Self-Assembled Reduced Graphene Oxide/Polyacrylamide
Substrate supported conductive thin films are prepared by the self-assembly of graphene oxide (GO) on a cationic polyacrylamide (CPAM) layer followed by a subsequent chemical reduction. During self-assembly, the dispersed GO nanosheets with a negative zeta potential from solution are spontaneously assembled onto the positively charged CPAM adsorption layer.
Among which the graphene related hydrogels with excellent mechanical properties have attracted great attention. However, the effect of these hydrogels on peripheral nerve regeneration is still unclear. In the present study, the graphene oxide/polyacrylamide (GO/PAM) composite hydrogels were fabricated by in-situ free radical polymerization.
Study on graphene-oxide-based polyacrylamide composite
XRD was an important tool for determining whether graphene-based sheets were indeed present as individual GO sheets in the nanocomposites . Fig. 2 showed the XRD patterns of GO, GO3–BIS1-gel (dried) and BIS-gel (dried). The typical diffraction peak of GO was observed at about 2θ = 10.98°.PAM exhibited a broad diffraction hump centered at about 2θ = 22.4°, indicating the almost amorphous
Reduced graphene oxide/polyacrylamide composite hydrogel scaffold as biocompatible anode for microbial fuel cell Chemical Engineering Journal ( IF 8.355) , DOI: Jia Yi Chen, Pu Xie, Ze Ping Zhang In this study, a reduced graphene oxide/polyacrylamide (rGO/PAM) three-dimensional (3D) composite hydrogel coupled with current collector graphite brush (GB) was developed as anode for microbial fuel
Self-Assembled Reduced Graphene Oxide/Polyacrylamide
Substrate supported conductive thin films are prepared by the self-assembly of graphene oxide (GO) on a cationic polyacrylamide (CPAM) layer followed by a subsequent chemical reduction. During self-assembly, the dispersed GO nanosheets with a negative zeta potential from solution are spontaneously assembled onto the positively charged CPAM adsorption layer.
A chemically cross-linked polyacrylamide gel (AM) prepared without graphene and a series of hybrid graphene-polyacrylamide gels (AMGX, being X the graphene concentration used in mg mL −1) were
Novel polyacrylamide hydrogels by highly conductive, water
Herein we employed two recipes in Table 2 to fabricate mildly oxidized graphene oxide sheets (MOGS) and slightly graphene oxide sheets (SOGS), and we anticipated the preparation conditions posing a marked effect on the suspension of graphene sheets in water. SOGS were found not suspending well in water, while MOGS suspended for 15 h at 0.2 wt%. It is likely that as-obtained MOGS are highly
MALAYSIA RESEARCH UNIVERSITY NETWORK MINISTRY OF EDUCATION. Titanium Dioxide/Agglomerated-Free Reduced Graphene Oxide Hybrid Photoanode Film For Dye-Sensitized Solar Cells Photovoltaic Performance Improvement Hydrogel Pore-Filled Composite Membranes With Switchable Sieving Functions NATIONAL CONGRESS ON MEMBRANE TECHNOLOGY (NATCOM) 2016
Adsorption of Malachite Green Dye from Liquid Phase Using
The scanning electron microscope (SEM) micrographs of the raw poly(AN-co-AA) and TU-poly(AN-co-AA)polymers are shown in Figure 2.The morphologies of both were similar to each other, and the surface of the TU-poly(AN-co-AA) polymer shows no significant cracks or degradation signal.They have almost uniform spherical morphology and porous surface suitable for adsorption binding sites.
Jo urn al Pr e-p roo f NOMENCLATURE EOR Enhanced Oil Recovery CEOR Chemical Enhanced Oil Recovery HPAM Partially hydrolyzed polyacrylamide DOH Degree of hydrolysis CONH2 Amide group COO Carbonyl group NP Nanoparticles HCS Hydrocarbons MW Molecular weight IFT Interfacial tension CNT Carbon nanotubes PAM Polyacrylamide HTHS High temperature high
Surface Modifications for Antifouling Membranes - Chemical
Surface Modifications for Antifouling Membranes. D. Rana * and T. Matsuura. (2003), University Technology Malaysia, Skudai, Malaysia (2007, 2009), at Myongji University, Yongjin, Korea (2008), as a visiting professor. Green Synthesis of Reduced Graphene Oxide/Polyaniline Composite and Its Application for Salt Rejection by Polysulfone
Graphene oxide-based hydrogels as a nanocarrier for anticancer drug delivery. Abdullah A.Ghawanmeh 1, Gomaa A. M. Ali 1,2, H. Algarni 3,4, Shaheen M. Sarkar 5, and Kwok Feng Chong 1 (*). 1 Faculty of Industrial Sciences & Technology, Universiti Malaysia Pahang, Gambang, 26300 Kuantan, Malaysia 2 Chemistry Department, Faculty of Science, Al ‒ Azhar University, Assiut, 71524, Egypt
- What is polyaluminium chloride production?
- PolyAluminium Chloride production is one of the most exigent process for glass-lined equipement due to its high corrosive and abrasive effect. That's why, the experience and the qualification of De Dietrich Process Systems allow to meet qualitatively those process requirements.
- What is poly aluminum chloride used for?
- Contact us! Poly aluminum chloride is used mainly to remove color and colloidal matter in aqueous systems. It is also used in water treatment plants, clarification of industrial effluents and as a replacement for aluminum sulfate, aluminum chloride, ferric chloride, ferric sulfate and other non-polymerized conventional inorganic salts.
- What is polyaluminum chloride (PAC)?
- Sci.882 012014DOI 10.1088/1755-1315/882/1/012014 Polyaluminum chloride (PAC) is commonly used as a chemical in the water treatment industry, deodorant and paper-making. The PAC is a complex inorganic substance between hydroxyl and aluminum ions that gradually takes place chlorination with its general formula of Al x (OH) y Cl 3x-y.
- Does pH affect the performance of polyaluminum chloride (PAC)?
- The performance of PAC was dependent on pH. The synthesized PΑC was efficient coagulant for water treatment. The present work was aimed to synthesis of polyaluminum chloride (PAC) using calcium oxide as a basification agent and optimization of process parameters on the yield of medium polymer species in PAC.
